Castleton-on-Hudson, NY
Schodack Auto
1525 Columbia Turnpike, Castleton-on-Hudson, NY 12033- Hours
- Mon – Fri 9:00 AM – 5:00 PM
- Phone
- (518) 477-2345
SERVICE 02 · FRAME & STRUCTURAL
Frame & Structural Repair in New York's Capital Region
Laser-measured straightening to factory tolerances.
THE WORK
Frame & structural at Eastern Collision Group.
Modern unibody vehicles are engineered to crush in specific places so that the passenger cell does not. Once that structure is bent, a car can still drive straight down a smooth road while being measurably out of spec — which shows up later as uneven tire wear, wind noise, doors and glass that no longer seal, and reduced protection in the next crash.
So we measure before we pull. Every structural job is checked against the manufacturer's dimensional data, straightened on the rack, then measured again to confirm the numbers are back inside factory tolerance. Where the maker specifies a section as replace-only, we replace it instead of pulling it back into shape.
Red Mill Auto in Rensselaer handles the heaviest structural work in the group, and any of the three shops can measure and diagnose a suspected frame problem before you commit to a repair.
WHERE
Frame & structural at all 3 of our shops.
Offered at Schodack Auto in Castleton-on-Hudson, Red Mill Auto in Rensselaer and Eastern Collision in Valatie. Book at whichever is closest — or see all 3 locations.
- Rensselaer, NY
Red Mill Auto
1139 Red Mill Rd, Rensselaer, NY 12144- Hours
- Mon – Fri 7:00 AM – 4:00 PM
- Phone
- (518) 275-0322
- Valatie, NY
Eastern Collision
3361 NY-9H, Valatie, NY 12184- Hours
- Mon – Fri 8:00 AM – 5:00 PM
- Phone
- (518) 758-7295
FAQ
Questions we get about frame & structural.
- Can a bent frame be repaired, or is the car totaled?
- Plenty of bent unibody structures can be brought back to factory specification. Whether it is worth doing is an economic question, not a technical one — we measure the damage, price the repair, and tell you honestly if it exceeds what the vehicle is worth.
- How do I know the frame is actually straight when you are done?
- We compare measurements to the manufacturer's published dimensions before and after the pull, and we will walk you through the readings.
- My car pulls to one side since the accident. Is that the frame?
- It could be structure, but it is just as often alignment or a bent suspension component. A measurement session tells you which, and it is the right first step before anyone starts replacing parts.
Ready when you are.
Get a free estimate at any Eastern Collision location in under two minutes. We'll handle the insurance paperwork from there.